Diesel Service
Full Test and Check of Your:
- Check and replace engine oil
- Replace oil filter
- Check Power steering fluid
- Test Battery
- Window blades and fluid and horn
- Radiator and coolant levels and condition of both
- Clutch and brake master cylinder fluid levels
- Battery fluid
- Check Engine for oil and engine leaks
- Transmisson Fluid, pan filter and pan Gasket (if applies)
- Transmission/Manual Gearbox oil (as applies)
- Brake fluid drained and replaced (if applies)
- Check Carburettor/Throttle body and Security
- Inspect idle stop solonoid (as applies)
- Idle speed/mixture adjustment (if applicable)
- Inspect feul rail for security and condition
- Diff and transaxle fluid
- Full tune (15 point)
Inspect and Full Checks on:
- Radiator and heater cores inspected
- Heater tap
- Vaccum lines and hoses inspected
- Visual check cooling system hoses
- Pressure check cooling system
- Water pump and fan clutch
- Hose clamps Pressure, cooling system
- Fan belt adjusted as required
- Transmission
- Battery Electrolyte level
- Battery Terminals inspection
- Power supply Cables checked for security
- Window Blades
- Air filter
- Feul hoses checked secured as needed
- Test brake lights. indicator and side and headlights
- Check steering componets
- Check Lubricate for steering stops
- Tyre pressure adjust as required and apply shine
- Check All brakes
- Check WOF expiry
- Fuel filter check
- Checks of fan Vee belts
- Spark plug checked for wear and ignition componets
Inspect and Full Checks on:
- Ignition leads inspected (bum marks/wear)
- Check Voltage output of ignition coils and condition
- Main engine earth check
- Adjust hand brakes
- Check Exhaust secureand for leaks
- Replace wiper refill
- Check Drive belts
- Shock absorber/struts checked
- Anaylse of exhaust gas
- Timing checks of ignition checked (if applicable)
- Cambelt tested
- Check Altamator voltage output under load
- Check starter motor for current draw
- Test park neutral switch operation
- Check mounting of power supply cables
- Check EFI Componets for security of operation
- Clean dash Board/empty ash tray
- Emmission Control System check
- Complete Engine Compression Test
- Check Feul injectors (as applies)
- Check Tappets or lifters for noise and report
- Inspect and check on timing belt
- Test operation of EGR valve
- Road test: Engine performance, braking
- Repack front and rear wheel bearings (if applicable)
- CV boot. driveline inspection
- Road test: Check of braking system. steering
- Suspension and overall accessories and lights